neo bar set up

The right choice if you're a power kiter.

Moderators: admin, Alex

Re: neo bar set up

Postby Michael » Fri 09 Oct 2009 09:46

Hello again!

Sorry for the confusion. What I mean was that you can move the centre line closer to the bar in order for trimming.

If you are still unsure, please send an e-mail to our support staff at service@invento-hq.com

again, detailed stating your problem.

Regards,

Michael
Michael
 

Re: neo bar set up

Postby peterm » Thu 08 Oct 2009 22:41

Michael wrote:Hello!

It will be possible to use the NEOII bar on a NEOI kite but please bear in mind removing the 5th line when you do so. Also, replacing the chicken loop is recommended.

Shortening the lines is recommend for bringing the bar closer to your body, however, please make absolutely sure that you shorten all lines to the correct and appropriate length, and watch the outer lines being in relation to the centre lines.

Best of luck!

Regards,

Michael


Hi that does not make sense to me as shortening all flying lines just brings the kite to me, not the bar.???
At the moment to reach the bar when i am water starting I need to keep the depower strap fully in.

So to get some power in the kite I then need to trim out, but this places the bar too dar away again and the kite back stalls. should i move the centre line closer to the bar and then adjust trim strap fully out or shorten the chicken loop?

I want to move the bar closer to me so that I can leave the depower strap trimmed fully out
peterm
HQ Newbie
 
Posts: 9
Joined: Tue 05 May 2009 00:50

Re: neo bar set up

Postby Michael » Thu 08 Oct 2009 12:01

Hello!

It will be possible to use the NEOII bar on a NEOI kite but please bear in mind removing the 5th line when you do so. Also, replacing the chicken loop is recommended.

Shortening the lines is recommend for bringing the bar closer to your body, however, please make absolutely sure that you shorten all lines to the correct and appropriate length, and watch the outer lines being in relation to the centre lines.

Best of luck!

Regards,

Michael
Michael
 

Re: neo bar set up

Postby peterm » Thu 08 Oct 2009 11:52

Ok, will the new bar be availlable to fit the neo 1?

I also want to shorten the depower rope on my 14, as i find that the bar is to far away from my body.

What is the recommended way to get the bar closer to me?
At the moment my arms are not long enough to reach it comfortably, this means im always pulling down on the bar, stalling the kite
peterm
HQ Newbie
 
Posts: 9
Joined: Tue 05 May 2009 00:50

Re: neo bar set up

Postby Michael » Mon 05 Oct 2009 08:29

Hello,

What you see on the picture is a prototype of our current bar with some experimental adjustments (i.e. attachment points on brake lines, different chicken loop etc.).

Our new bar will be available shortly so please keep checking our website for news and updates.

Regards,


Michael
Michael
 

neo bar set up

Postby peterm » Mon 05 Oct 2009 00:47

neo 8 bar setup cropped.jpg
Hi, i was looking at your web site and the main banner shows a NEO 8 with a rider and different bar setup. [pic attached]

More attachment points on brake lines, different chicken loop and bar.

Is this the new bar?
peterm
HQ Newbie
 
Posts: 9
Joined: Tue 05 May 2009 00:50


Return to Powerkites

Who is online

Users browsing this forum: No registered users

cron